HIKVISION DS-K3B220X Series, Руководство пользователя

Страница: 32 / 115

Note
●
The power cable from power supply to the main lane control board has been connected. You will
need to prepare the 14AWG power cable to connect the AC power input to power supply.
●
The supplied 2 interconnecting cables need connecting on-site:
1. 24 V power cable of 14 AWG. The cable is 5 m in length and put inside the right/middle
pedestal at the exit.
2. UTP-5e Communication cable. The cable is 3 m in length and put inside the package of the
right/middle pedestal.
●
The ① and ② or ③ and ④ refer to the two sides of a same board.
●
Barrier opens at the entrance/exit: connect to BTN1/BTN2 and GND.
4.3.8 RS-485 Wiring
The RS-485 interfaces on the access control board are suggested to connect with the face
recognition module or the card reader. Here takes connecting with a card reader as an example.
Note
●
There are 2 RS-485 interfaces on the access control board for entrance. Refer to Access Control
Board Terminal Description for details.
There are 2 RS-485 interfaces on the sub optional board for exit. Refer to Sub Optional Board
Terminal Description (Optional) for details.
●
If connecting the RS-485 with a card reader, by default, the DIP switch of the card reader is: 1 for
entrance, and 4 for exit.
●
If there are other RS-485 devices connecting, the ID of the RS-485 cannot be conflicted.
●
The connected 12 V power interface for the face recognition terminal cannot be connected with
other 12 V devices.
Figure 4-10 Wiring RS-485
DS-K3B220X Series Swing Barrier User Manual
20