HIKVISION DS-8508NIST, Руководство пользователя

Страница: 56 / 122

User Manual of Network Video Recorder
55
9.1 Basic Configuration
Steps:
1. Enter basic configuration interface
Configuration> Remote Configuration> Network Settings> TCP/IP
Figure 9. 1 Network Settings Interface
2. In the General Settings interface, you can configure the following settings: Working Mode, NIC Type, IPv4
Address, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to automatically obtain an IP address
and other network settings from that server.
Note: The valid value range of MTU is 500 ~ 9676.
3. After having configured the general settings, click Save to save the settings.
Working Mode
There are two 10M/100M/1000M NIC cards provided by the NVR, and it allows the device to work in the
Multi-address, Load Balance and Net-fault Tolerance modes.
Multi-address Mode: The parameters of the two NIC cards can be configured independently. You can select
LAN1 or LAN2 in the NIC type field for parameter settings.
You can select one NIC card as default route. And then the system is connecting with the extranet and the data will
be forwarded through the default route.
Net-fault Tolerance Mode: The two NIC cards use the same IP address, and you can select the Main NIC to
LAN1 or LAN2. By this way, in case of one NIC card failure, the device will automatically enable the other
standby NIC card so as to ensure the normal running of the whole system.
Load Balance Mode: By using the same IP address and two NIC cards share the load of the total bandwidth,
which enables the system to provide two Gigabit network capacity.