HIKVISION DS-8100HDI-S Series, Руководство пользователя

Страница: 32 / 70

32
6.
Select the start and stop time for each day of the week. The start and stop time are listed using a 24 hr cycle (i.e.
18:00 is equivalent to 6:00pm).
7.
Select
Recording Type
for each day of the week. Recording type includes
Continuous
for continuous recording or
On Event
for recording when an event is triggered (i.e. from detected motion) for the selected time period.
8.
Check the
Enable Audio
checkbox if you would like to enable audio recording along with the video. Audio can
only be recorded if an audio source (such as a microphone) is connected to the DVR.
9.
Select the Save button to save the schedule settings and select Exit to return to the previous menu. Selecting the
Exit button without clicking Save will quit out of the menu without saving settings.
Note:
On Event
recordings are recordings that are triggered from motion detection and/ or from an external alarm (See
Configuring Alarms and Exceptions
on page 61).
Note:
If an event occurs during
Continuous
recording, the frame rate will automatically switch to that set for
Event
recording.
Configuring an Advanced Recording Schedule
An advanced recording schedule allows you to schedule multiple time periods per day for recording as oppose to a single
time period of a quick recording schedule. Setting up an advanced recording schedule will allow you to further conserve
disk space by recording only during the time periods you would like to record at.
To setup an advanced recording schedule:
1.
Enter the Advanced Schedule Configuration menu, shown in Figure 24 by going to Main Menu > Recording
Configuration > Advanced Schedule Configuration.
Figure 24. Advanced Schedule Configuration Menu
2.
Select the camera to configure from the camera drop down menu. If all the cameras are to be configured with the
same settings, select
All Cameras
from the list.
3.
Check the
Enable
checkbox to enable the recording schedule. If the checkbox is unchecked, the recording
schedule will be disabled.
4.
Select a day between Monday to Sunday to configure schedule for.
5.
Setup time periods for schedule. If the
24HR
checkbox is checked, recording will occur over the entire day. To
setup multiple time periods, uncheck
24HR
and enter the
Start
and
Stop Time
for the selected day. The start and
stop time are listed using a 24 hr cycle (i.e. 18:00 is equivalent to 6:00pm).
6.
Select recording type under
Type
for selected day of the week. Recording type includes
Continuous
for
continuous recording or
On Event
for recording when an event is triggered (i.e. from detected motion) for the
selected time period.