HIKVISION DS-7600NI-SP Series, Краткое руководство по эксплуатации

Страница: 188 / 245

User Manual of DS-9600/8600/7700/7600NI-ST and DS-7700/7600NI-SP Series NVR
154
SMTP Server: The SMTP Server IP address or host name (e.g., smtp.263xmail.com).
SMTP Port No.: The SMTP port. The default TCP/IP port used for SMTP is 25.
Enable SSL (optional): Click the checkbox to enable SSL if required by the SMTP server.
Sender: The name of sender.
Sender’s Address: The Email address of sender.
Select Receivers: Select the receiver. Up to 3 receivers can be configured.
Receiver: The name of user to be notified.
Receiver’s Address: The Email address of user to be notified.
Enable Attached Pictures:
Check the checkbox of
Enable Attached Picture
if you want to send email
with attached alarm images. The interval is the time of two adjacent alarm images. You can also set
SMTP port and enable SSL here.
Interval:
The interval refers to the time between two actions of sending attached pictures.
E-mail Test:
Sends a test message to verify that the SMTP server can be reached.
6. Click button to save the Email settings.
7.
You can click to test whether your Email settings work. The corresponding Attention
message box will pop up. Refer to Figure 9. 22.
Figure 9. 22 Email Testing Attention
9.2.10 Configuring UPnP
Purpose:
UPnP can permit the device seamlessly discover the presence of other network devices on the network and establish
functional network services for data sharing, communications, etc. If you want to use the UPnP function to enable
the fast connection of the device to the WAN via a router, you should configure the UPnP parameters of the device.
Before you start:
If you want to enable the UPnP function of the device, you must enable the UPnP function of the router to which your
device is connected. When the network working mode of the device is set as multi-address, the default route address
of the device should be in the same network segment as that of the LAN IP address of the router.
Steps:
1.
Enter the Network Settings interface.
Menu > Configuration > Network
2.
Select the
UPnP
tab to enter the UPnP interface.