DS-6600 Series DVS Quick Operation Guide
17
Note:
Before using two-way audio function or recording with audio, please select the
Stream Type
to
Video &
Audio
under
Remote Configuration >
Camera Settings >Video Settings
.
Full-screen Mode
You can double click on the live video to switch to the full-screen view mode. To switch back to the normal mode,
double click on the live video again.
Operating PTZ Control
Before you start:
1.
Make sure the encoder is connected with the camera/dome which supports PTZ function. Connect the
R+
and
R
-
terminals of the pan/tilt unit or speed dome to RS-485 T+ and RS-485 T- terminals of the DS-6600
respectively.
2.
The baud rate, PTZ control and address configured in the
RS-485 Settings
interface
(
Remote
Configuration > Serial Port Settings > 485 Serial Port
) must be the same with the parameters of the
connected pan/tilt unit or speed dome.
Operating PTZ Control
In live view mode, you are allowed to use the PTZ control buttons to realize pan/tilt/zoom control of the camera
lens.
There will be 8 directional buttons (up, down, left, right, upper left, upper right, bottom left, bottom right) on the
display window when the mouse is located in the relative positions.
Click on the directional buttons to control the pan/tilt movement.
Click the zoom/iris/focus buttons to realize lens control.
Refer to the following table for description of PTZ control buttons:
Button
Description
Zoom in/out
Focus near/far
Iris open/close
Lighter on/off
Wiper on/off
Adjust speed of pan/tilt movement
(level 1~ 7 is selectable)
