2. Hold the SFP optical module from one side, and smoothly plug
it into the device along with the SFP port slot until the optical
module and the device are closely attached.
3. After powering on the device, check the status of LINK/ACT
indicator. If the indicator is lit, the link is connected. If the
indicator is unlit, the link is disconnected. Check the line, and
make sure peer devices have been started.
4 Powering on the Device
Please use the attached power cord in package to power on the
device.
Before powering your switch, make sure that:
• The operating power supply is compliant with rated input
standard.
• Port cables and grounding cables are correctly connected.
• If there is outdoor cabling, connect a lightning rod and
lightening arrester to the cable.
Caution
PoE power supply line and strong wire cannot be wired together,
otherwise PD equipment or switch ports will be burnt.
5 Device Management
The device can be configured and managed through iVMS-4200
software, mainly including network parameter configuration, port
configuration, link aggregation configuration, network topology
display and so on.
Note
• This chapter will briefly introduce the device management
through the iVMS-4200 software. For other functions, please
refer to User Manual of iVMS-4200 Client Software.
• All pictures in this manual are for illustration only, and the
specific interface is subject to the actual interface.
5.1 Activating Devices
For the inactive devices, you are required to create a password to
activate them before they can be added to the software and work
properly.
Before You Start
Make sure the device to be activated is connected to the network
and is in the same subnet with the PC running the client.
Steps
Note
This function should be supported by the device.
1. Enter the Device Management page.
2. Click Device tab on the top of the right panel.
6
