Speed Dome
PC
Network
Cable
Network
Cable
Internet
11
User Manual of Thermal Network Speed dome
Figure 2-11 Accessing the Speed dome with Static IP Directly
2.2.2
Dynamic IP Connection
Before you start:
Please apply a dynamic IP from an ISP. With the dynamic IP address, you can connect the
network speed dome to a modem or a router.
Connecting the network speed dome via a router
Steps:
1.
Connect the network speed dome to the router.
2.
In the speed dome, assign a LAN IP address, the subnet mask and the gateway. Refer
to
Section 2.1.2
for detailed LAN configuration.
3.
In the router, set the PPPoE user name, password and confirm the password.
For your privacy and to better protect your system against security risks, we
strongly recommend the use of strong passwords for all functions and network
devices. The password should be something of your own choosing (using a
minimum of 8 characters, including upper case letters, lower case letters, numbers
and special characters) in order to increase the security of your product.
Proper configuration of all passwords and other security settings is the
responsibility of the installer and/or end-user.
4.
Set port mapping. E.g. 80, 8000 and 554 ports. The steps for port mapping vary
depending on different routers. Please call the router manufacturer for assistance with
port mapping.
5.
Apply a domain name from a domain name provider.
6.
Configure the DDNS settings in the setting interface of the router.
7.
Visit the speed dome via the applied domain name.
Connecting the network speed dome via a modem
Purpose:
This speed dome supports the PPPoE auto dial-up function. The speed dome gets a public
IP address by ADSL dial-up after the speed dome is connected to a modem. You need to
configure the PPPoE parameters of the network speed dome. Refer to
Section 7.1.1
Configuring PPPoE Settings
for detailed configuration.
© Hikvision
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]