Color Zoom Camera User Manual
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
31
The
EZOOM
can be set to OFF, x2, x4, x6, x8, x10, x12, x14 and x16. The maximum optical zoom is
23X. 2 times 23X is 46X. If you choose x2, the maximum digital zoom can reach to 46X. The camera
zooms electronically after reaching to the value 23x.
ZOOMDISP
There are two
ZOOMDISP
modes:
ON
: The zoom value will be displayed on the top right of the screen when you press the T/W
buttons.
OFF
: The zoom value will not be displayed on the top right of the screen when you press the T/W
buttons.
ZCFMOD
The
ZCFMOD
can be set to
MODE1
and
MODE2
.
When you select the
MODE1
, the zoom in voltage is from +3V to +12V. The zoom out voltage is from
-3V to -12V.
When you select the
MODE2
, the zoom in voltage is from -3V to -12V. The zoom out voltage is from
+3V to +12V.
The voltage of the focus near and far is the same as the zoom in and out in these two modes.
RS-485
Before you use the RS-485 interface to send control signal to the camera, you have to configure the
RS-485 parameters first.
PROTOCOL
: The control protocol is PELCO-D. It is not adjustable.
BAUDRATE
: The baudrate can be set to 1200, 2400, 4800, 9600, 19200 and 38400.
ADDRESS
: Choose a number as the address of the camera. It is for the control device to distinguish
the different cameras when there are multiple cameras to control.
Figure 3.2.12 RS-485 Settings
PRESET
There are up to 254 presets that can be configured.
RS485
PROTOCOL PELCO-D
BAUDRATE 2400
ADDRESS 001
RET
