Note:
Drill the cable hole in the center of the drill template,
when adopting the ceiling outlet to route the cable.
5.
Secure the mounting base to the ceiling with the
supplied screws.
Fixing Screw
Expansion Bolts
Figure 2-12
Fix the Mounting Base to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
6.
Route the cables through the cable hole, or the side
opening.
7.
Secure the camera on the mounting base.
Figure 2-13
Secure the Camera
8.
Connect the corresponding cables, such as power
cord, and video cable.
9.
Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Tilt Position
[0°to75°]
Pan Position
[0° to 360°]
Rotation Position
[0° to 360°]
Figure 2-14
3-axis Adjustment
1).
Hold the camera body and rotate the enclosure
to adjust the pan position [0° to 360°].
2).
Move the camera body up and down to adjust
the tilt position [0° to 75°].
3).
Rotate the camera body to adjust the rotation
position [0° to 360°].
2.3
Installation of Type I and Type II Camera
2.3.1
Ceiling/Wall Mounting with Junction Box
Steps:
1.
Paste the drill template on the ceiling/wall.
2.
Drill screw holes and the cable hole (optional) in the
ceiling/wall according to the holes of the drill
template.
