Video Wall Controller • User Manual
6
View the Receiving Card Status
Enter Video Wall Configuration
→
Decoding Output. Select LED sending card in the Output List
(Example of naming the LED sending card: LEDSendCard_Board19_1). Right-click and select Signal
Cable Configuration.
1. Click Load from the Screen, the screen type will be displayed automatically.
2. Click Signal Source Configuration. Check Display Actual Lines on Screen.
3. Click the sending port of the sending card on the left.
4. According to the cabinet number on site, click the frame on the right to connect the sending
card with the cabinet screen.
5. The following parameters can also be set during the connection.
Marking Type: Supports quick connection according to the layout of the receiving card on site.
Example: When the marking type is Z Shape, select the sending port of the sending card, and
click the start point and end point of the frame on the right according to the cabinet number
on site to make quick connection.
Cancel: Cancel the previous operation.
Restore: Restore the previous operation.
Reset Current Sending Port: Click the sending port of the sending card on the left. Then click
Reset Current Sending Port to reset the connection settings of the selected sending port.