HIKVISION 5 Inch Network High Speed Dome, Руководство по установке, Страница: 17 / 53

5 Inch Speed Dome Installation Manual V2.0.0
16
1.4.2 DIP Switch Settings for Medium Speed Dome and Network
High-definition High Speed Dome
Figure 1.4.2 DIP Switch Location on Side of Dome Drive
The circuit board of the dome drive provides two DIP switches
SW1
and
SW2
for setting the dome address, baud rate, protocol, etc. As
shown in Figure 1.4.2, ON=1, OFF=0. In SW1 and SW2, 1 is the lowest position and 8 is the highest position. Please refer to the
following list for specific settings:
Note:
The network speed dome is self-adaptive to Pelco-P, Pelco-D and PRIVATE-Code protocols, no DIP switch settings for control
protocol are required.
1.4.3 Address Settings
The DIP Switch SW1 is used for setting the dome address:
Dome Address SW1 Settings 1 2 3 4 5 6 7 8
0 OFF OFF OFF OFF OFF OFF OFF OFF
1 ON OFF OFF OFF OFF OFF OFF OFF
255 ON ON ON ON ON ON ON ON