8
English
left in ON position when power resumes,
the restart of the fan may cause
fi
re.
CAUTION
1. Parts of the nozzle supplied are sharp,
so use gloves when removing them
from the case and when attaching or
detaching them.
2. The hot wind release nozzle, the tip of
the nozzle and the material that was
heated are extremely hot during and
immediately after using the tool, so use
gloves and avoid touching them directly.
3. Do not use inside boxes, drawers or
other enclosed spaces.
Aiming it constantly at a single location
may result in the outbreak of smoke or
fi
re.
4. Make sure the nozzle is at least 5cm
away from the item being heated when
using the tool. Also, do not cover or
otherwise block the nozzle.
Failure to observe this may result in
the Heat Gun overheating, leading to
malfunctions.
5. Do not switch the tool on and o
ff
repeatedly. Also, do not use the tool with
the power cord folded or twisted.
Failure to observe this may result in
malfunctions.
6. Do not point the heat-wind release
nozzle downwards immediately after
use.
Failure to observe this may result in the
tool overheating, leading to malfunctions.
SPECIFICATIONS
Power supply
Type
Can be used with both 50 Hz and 60 Hz single-phase current.
Voltage
110 V
120 V to 127 V
220 V to 240 V
Rated electrical
current
12.9 A
12.2 A
8.8 A
Power Input
1375 W
1500 W
2000 W
Capacity
Wind volume
0.25 m
3
/min to 0.5 m
3
/min (2-stage switch)
Wind temperature
250 – 500°C
2-stage switch
50°C
(When the cooling button is used.)
350 – 500°C
2-stage switch
50°C
(When the cooling button is used.)
450 – 600°C
2-stage switch
50°C
(When the cooling button is used.)
Motor type
Direct current motor
Weight
0.57 Kg
STANDARD ACCESSORIES
1
Nozzle (round) ............................................................. 1
2
Nozzle (
fl
at) ..................................................................1
3
Nozzle (curved surface) ...............................................1
4
Nozzle (glass protector) ...............................................1
5
Scraper (with grip) ........................................................1
6
Case .............................................................................1
Standard accessories are subject to change without notice.
APPLICATIONS
○
Peeling o
ff
paint
○
Softening adhesive
○
Removing putty from window frames
○
Forming resin pipes
○
Welding plastic
○
Heat wrapping using heat-shrink
fi
lm.
○
Soldering
○
Drying work
○
Defrosting work
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements speci
fi
ed on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the power
switch is in the ON position, the power tool will start
operating immediately, which could cause a serious
accident.
3. Extension cord
When the work area is removed from the power source,
use an extension cord of su
ffi
cient thickness and rated
capacity. The extension cord should be kept as short as
practicable.
00Book̲RH600T̲EE.indb 8
00Book̲RH600T̲EE.indb 8
2019/07/29 14:33:25
2019/07/29 14:33:25
Автотовары
«130»
130.com.ua
