HIKOKI G 3613DVE, Инструкция по эксплуатации

Страница: 14 / 24

14
○ Restart prevention function
When the power is still switched on, the tool will not
restart when a battery is installed. This function can be
canceled once the tool is switched o ff .
○ Brake function
Brake activates when the switch is o ff .
CAUTION
When using ET36A, this function does not operate.
○ Drop shut o ff function <G3613DVE>
When the drop shut o ff function has been activated, the
motor may stop.
In this case, release the tool switch.
After that you can use it again.
2. Battery
Model BSL36A18
Voltage 36 V / 18 V (Automatic Switching*)
Battery capacity
2.5 Ah / 5.0 Ah
(Automatic Switching*)
* The tool itself will automatically switch over.
** Please see our general catalogue for details.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger’s power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the charge indicator lamp will blink in red (At 1- second
intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in
Fig. 4 (on page 2).
3. Charging
When inserting a battery in the charger, the charge
indicator lamp will blink in blue.
When the battery becomes fully recharged, the charge
indicator lamp will light up in green. (See Table 1 )
(1) Charge indicator lamp indication
The indications of the charge indicator lamp will be as
shown in Table 1 , according to the condition of the
charger or the rechargeable battery.
Table 1
Charger
status
Status of indicator
lamp
Indication meaning
Before
charging
ON/OFF at 0.5 sec.
intervals (RED)
Plugged into power
source *
1
While
charging
Lights for 0.5 sec. at
intervals of 1 sec.
(BLUE)
Charged at less than
50%
Lights for 1 sec. at
intervals of 0.5 sec.
(BLUE)
Charged at less than
80%
Lights continuously
(BLUE)
Charged at more
than 80%
Charging
complete
Lights continuously
(GREEN)
(Continuous buzzer
sound: about 6 sec.)
Overheat
standby
ON/OFF at 0.3 sec.
intervals (RED)
Battery overheated.
Unable to charge. *
2
Charging
impossible
ON/OFF at 0.1 sec.
intervals (PURPLE)
(Intermittent buzzer
sound: about 2 sec.)
Malfunction in
the battery or the
charger * 3
*1 If the red lamp continues to blink even after the charger
has been attached, check to con fi rm that the battery has
been fully inserted.
*2 Although charging will start once the battery has cooled
down even when left in situ, the best practice is to
remove the battery and allow it to cool down in a shaded,
well-ventilated location before charging.
*3
○ Fully insert the battery.
○ Check to con fi rm that no foreign matter is stuck to the
battery mount or terminals.
<If charging takes a long time>
○ Charging will take longer at extremely low ambient
temperatures. Charge the battery in a warm location
(such as indoors).
○ Do not block the air vent. Otherwise the interior will
overheat, reducing the charger’s performance.
○ If the cooling fan is not operating, contact a HiKOKI
Authorized Service Center for repairs.
00Book̲G3613DVE̲Aust.indb 14 00Book̲G3613DVE̲Aust.indb 14 2022/08/26 15:06:37 2022/08/26 15:06:37