English
27
7. Cleaning
If the machine becomes dirty, carefully wipe it down with
a cloth soaked in soapy water and wrung out.
If the laser line becomes di
ffi
cult to see due to chips
or other debris on the laser marker window, wipe the
window with a dry cloth or soapy water.
Do not use gasoline, thinner, benzine or kerosene as
they will dissolve the plastic. Do not allow the motor to
become wet with water or oil.
8. Transporting the machine
WARNING
When transporting the machine, remove the sub table
holder and sub table assembly.
If they fall out from the machine, they may cause injury.
CAUTION
Be sure to turn o
ff
the switch and remove the battery
from the tool main unit when transporting the machine.
The vise device may fall during transportation. Remove it
or secure it by clamping a piece of wood.
Lower the head and insert the locking pin.
At the position where hinge (A) abuts with holder (A), tighten
the slide
fi
xing wing bolt to
fi
x the head. (
Fig. 62
)
Holder (A)
Slide securing
wing bolt
Abut
Hinge (A)
Fig. 62
To
fi
x the turntable, turn the side handle to loosen it, rotate the
turntable as far as it will go to the right, and turn the handle to
the
fi
x it. This makes the machine more compact. (
Fig. 63
)
Insert
Base handle
Lower the head
Locking pin
Fix by clamping
a piece of wood
Carry handle
Vise assembly
Side handle
Fig. 63
Next, carry the machine, holding the carry handle with one
hand and the handle on the left side of the base in your other
hand for support.
9. Storage after work
When out of use, store the machine and accessories
in a safe and dry place, and avoid storing them in the
following places.
NOTE
○
Places where children can reach the machine or
accessories and take them out
○
Places where they may be exposed to rain such as
eaves or humid places
○
Places where the temperature changes suddenly or that
are exposed to direct sunlight
○
Places with volatile substances that may catch
fi
re or
explode
Storing in a place below 40°C and out of the reach of
children.
NOTE
Storing lithium-ion batteries.
Make sure the lithium-ion batteries have been fully
charged before storing them.
Prolonged storage (3 months or more) of batteries with
a low charge may result in performance deterioration,
signi
fi
cantly reducing battery usage time or rendering
the batteries incapable of holding a charge.
However,
signi
fi
cantly reduced battery usage time may
be recovered by repeatedly charging and using the
batteries two to
fi
ve times.
If the battery usage time is extremely short despite
repeated charging and use, consider the batteries dead
and purchase new batteries.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
Important notice on the batteries for the HiKOKI
cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used with
batteries other than these designated by us, or when
the battery is disassembled and modi
fi
ed (such as
disassembly and replacement of cells or other internal
parts).
NOTE
Due to HiKOKI’s continuing program of research and
development, the speci
fi
cations herein are subject to
change without prior notice.
00Book̲C3607DRA̲ChT.indb 27
00Book̲C3607DRA̲ChT.indb 27
2020/07/20 11:36:18
2020/07/20 11:36:18
