English
11
When cutting, if you slide the head part forward and push
down, the main unit may rattle.
Turn the set screw left or right to adjust it so that it
touches the bottom lightly. (
Fig. 8
)
Set screw
Lower
Raise
Fig. 8
3. Releasing the locking pin
When shipped from the factory, the head is
fi
xed with a
locking pin.
Before use, pull the locking pin in the direction of the
arrow.
The locking pin can be pulled out easily if you slightly
lower the handle. (
Fig. 9
)
When transporting the machine, push down the handle
and push in the locking pin to
fi
x the head.
Pull
Head locking is released
Locking pin
Lower the
handle
slightly
Fig. 9
4. Installation of standard accessories
Attach the standard accessory dust bag, holder, sub
table assembly, and side handle as shown in
Fig. 10
.
Dust bag
Head part
Sub table assembly
6 mm knob bolt
Holder
Side handle
Close
Fig. 10
The holder and sub table assembly are used to stabilize
long cutting materials.
Use a carpenter's square or similar to ensure that the
base and sub table assembly match.
Turn the set screw for height adjustment and move sub
table assembly up and down to adjust them (
Fig. 11
).
After
adjustment,
fi
x the holder with the 6 mm knob bolt
(standard accessory) at the rear of the base, and
fi
x the
6 mm knob bolt on the sub table assembly.
Base top surface
Set screw
Holder
Carpenter's
square
6 mm knob bolt
Sub table assembly
6 mm knob bolt
(standard accessory)
Fig. 11
00Book̲C3607DRA̲ChT.indb 11
00Book̲C3607DRA̲ChT.indb 11
2020/07/20 11:36:06
2020/07/20 11:36:06
