English
50
9. Cutting narrow workpieces (Press cutting) (
Fig. 19
)
Slide the hinge down to holder (A), then tighten the slide securing knob (
Fig. 2 on
page 37
). Lower the handle to cut the workpiece. Using the power tool this way will permit
cutting of workpieces of up to 107 mm square.
3
1
2
Slide Securing
Knob Hinge Holder (A)
Fig. 19
Handle
Workpiece
10. Cutting large workpieces (
Fig. 20, 21
)
There may be case when a complete
cutting cannot be done depending on the
height of workpiece. In this case, mount
an auxiliary board with the 6 mm
fl
at head
screws and the 6 mm nuts using the 7 mm
holes on the fence surface (two holes on
each side). (
Fig. 20
)
Refer to “SPECIFICATIONS” for the
thickness of the auxiliary board.
NOTE
When cutting a workpiece exceeding 107
mm in height in right-angle cutting or 70
mm in left bevel angle cutting or 45 mm in
right bevel angle cutting, adjust the lower
limit position so that the base of the motor
head will not come in contact with the
workpiece.
To adjust the lower limit position of the saw blade, follow the procedure (1) shown in
Fig. 21
.
(1) Lower the motor head, and turn the 8 mm depth adjustment bolt and make adjustments so
that there can be a clearance of 2 mm to 3 mm between the lower limit position of the motor
head and the top of the workpiece at the saw blade's lower limit position where the head of
the 8 mm depth adjustment bolt contacts the hinge.
Fig. 21
Hinge
6 mm Depth
adjustment
bolt
Fence
6 mm Nut
6 mm Flat
Head Screw
Auxiliary
Board
Fig. 20
000Book̲C12RSH2̲ChS.indb 50
000Book̲C12RSH2̲ChS.indb 50
2018/03/27 15:00:46
2018/03/27 15:00:46
