HIKOKI C 12RSH2, Инструкция по эксплуатации

Страница: 42 / 64

English
42
7. Installation ( Fig. 4 )
Ensure that the machine is always fi xed to bench.
Attach the power tool to a level, horizontal work
bench.
Select 8 mm diameter bolts suitable in length for
the thickness of the work bench.
Bolt length should be at least 40 mm plus the
thickness of the work bench.
For example, use 8 mm x 65 mm bolts for a 25
mm thick work bench.
8. Base holder adjustment ( Fig. 5 )
Loosen the 6 mm bolt with the supplied 10 mm
box wrench. Adjust the base holder until its
bottom surface contacts the bench or the fl oor
surface.
After adjustment, fi rmly tighten the 6 mm bolt.
9. Check to see that the lower guard operates
smoothly
CAUTION
This slide compound miter saw is
equipped with a saw head lock as
safety device.
(1) When you push down the handle, check
that the lower guard revolves smoothly
( Fig. 6 ).
(2) Next, check that the lower guard returns
to the original position when the handle is
raised.
10. Oblique angle
Before the power tool is shipped from the factory, it
is adjusted for 0°, right angle, left 45° bevel cutting
angle and right 45° bevel cutting angle with the 8 mm
set screw, 8 mm bolt (A) and 8 mm bolt (B).
When changing the adjustment, change the height of
the 8 mm set screw, 8 mm bolt (A), or 8 mm bolt (B)
by turning them.
4 – ø9 mm
25
5.
5 m
m
327 mm 282 mm
Base 8 mm Bolt
Work bench 8 mm Nut
25 mm
thick
bench
Fig. 4
Fig. 5
6 mm
Bolt
Holder
Fig. 6
Lower
Guard
Handle
000Book̲C12RSH2̲ChS.indb 42 000Book̲C12RSH2̲ChS.indb 42 2018/03/27 15:00:41 2018/03/27 15:00:41