Higo 5531, Перевод оригинального руководства пользователя

Страница: 24 / 27

HHG-2000
5531
“EGA" Spółka z o.o. Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański, www.higo-tools.com
22
2.Power source Ensure that the power source to which is to be
connected to a heat gun corresponds with its parameters with the requirements specified on
the rating plate heat gun.
3.The switch Make sure the switch is in the off position. If you insert the plug into a power
outlet when the switch is in the On position can lead to a serious accident because the heat
gun immediately starts working.
4.Extension cord When the work area is far from a power outlet, use an extension cord of
an appropriate wire cross section adapted to the size of the current drawn. It is important to
use an extension cord as short as possible.
5.Check the operation launched a heat gun should work equally, without jamming. Only
such a device allowed to work
Removing paint
Turn on the heat gun and set the correct operating temperature
1.Direct the stream of hot air on the surface coated with paint. After a short time, the paint
will start to develop blisters. Do not allow to burn paint this as it impedes its removal.
2.By removing paint with a scraper or spatula should act this exercise movements from top
to bottom, gradually. If the spatula encounters a place where the paint can not be removed
carefully with a heat gun approach to facilitate further remove paint. From time to time you
should clean the spatula blade.
3.It should remove paint prior to its hardening, because otherwise it will adhere to the edge
of a putty knife.
4.After working leftover paint should be quickly removed from the spatula with a wire brush
before it solidified.
Shortly after the work is hot air gun nozzle. Avoid direct contact and wear suitable protective
gloves or wait until cool down. Do removal of the heated paint with a heat gun must not be
used spatula made of plastic.
Care and Maintenance
Before carrying out any activities related to installation, adjustment, repair or servicing
unplug the power cord from the wall outlet.
1.Heat guns must be kept clean, ensuring the free flow of air.
2.Heat Gun protect against contact with water.
3.To clean the heat gun, do not use water or chemical cleaners.