L4000G4
NEW LEADER
HEADER
19
Please Give Part No., Description
& Unit Serial No.
307074-D
Page Rev. A
GENERAL OPERATING PROCEDURES
1.
Make sure unit has been properly serviced and is in good operating condition. Field test unit prior to first use,
prior to each spreading season’s use, and following overhaul or repair work, to verify that all components and
systems are functioning properly. See
Field Testing
section.
2.
Fill body with material to be spread.
3.
Drive to location where spreading is to be done.
4.
Adjust spinner control valve for material being applied to give spread width desired. See
G4 Spread Pattern
section.
5.
Adjust spinner to give spread pattern desired. See
G4 Spread Pattern
section.
6.
Set rear feedgate opening to obtain yield desired. Turn feedgate handle to adjust L4000G4 feedgate opening.
7.
Make sure shut-off valve on hydraulic reservoir is fully opened.
8.
Turn on power to controller and set program to desired values.
9.
Engage pump drive PTO.
CAUTION
Drive only at speeds which permit good control of vehicle!
10.
Drive at speeds that allow engine to turn at proper RPM.
Higher transmission gears may be used with speeds to 30 MPH. If lower speeds must be used, shift transmission
into lower gears so that engine speed can be maintained to allow adequate hydraulic oil delivery from pump.
NOTICE!
CHANGE HYDRAULIC OIL FILTER AFTER FIRST WEEK (OR NOT MORE THAN 50 HOURS) OF OPERATION
ON A UNIT.
*Visit
www.newleadervip.com
for interactive tools to calculate yield, proper feedgate opening, conveyor revolutions
per minute, and mph to maximize the performance of your spreader.
O
P
E
R
.
&
M
A
I
N
T
.
O
P
E
R
A
T
I
N
G
P
R
O
C
E
D
U
R
E
S
All manuals and user guides at all-guides.com
