HIGHWAYGUARD.COM
_
Revision 1.0
–
03/19
© 2019 Highway Care Limited. All Rights Reserved.
Page 10 / 23
_
Installation
HighwayGuard™ must be installed in accordance with this manual and with the latest
state road
authority conditions. Where conflict arises road authority conditions take priority over this
manual.
Planning
Prior to starting an installation, it is recommended that the customer informs the installer of;
-
Start/end positions and alignment requirements of each barrier run (including crash
cushions)
-
Curvature (horizontal and vertical) required to ensure appropriate components available
-
Installation site risks identified (e.g. overhead cables, bridges, tunnels, drilling limitations)
-
Traffic management measures in place to ensure appropriate and safe working space
Tools List
(T)ool / (C)onsumable
Information
(T) Magnetic T-Bar Socket
For inserting and removing the T-Connector security nut.
(T) Drilling Equipment
Electric or air driven rock drill. Suggested drill bits are 28mm (M24
resin anchors) 400mm long.
(T) Measuring Wheel & (C)
Road Marking Paint
To mark barrier position where required.
(T) 2 off 2m crow
bar/wrecking bar
To assist with minor barrier re-alignment.
(T) Sledge Hammer
To hammer in anchor pins.
(T) Cranked Crow Bar
Useful for removing tight pins.
(T) Timber Blocks
To aid installation/removal on uneven ground.
(T) Wrench
With 36mm socket.
(C) Resin
Resin for M24 threaded anchor
