Highlight MAGNUM 1300 TB-U, Руководство по эксплуатации

Страница: 31 / 53

TROUBLESHOOTING GUIDE
This troubleshooting guide is not designed to solve all system problems. Rather, it is
designed to give you, the customer, a few quick checks and adjustments of the obvious,
but often overlooked items to keep your downtime to a minimum. Further help is
always available from
Highlight Industries’ experienced Mechanical/Electrical Service
Department.
Trouble Solution
Machine
does not
start Check that the power cord functioning.
Release the EMERGENCY STOP button.
Press START button to release load.
Check if fuse is in good condition. If faulty, replace with a new fuse as
shown in figure below.
Confirm the steps above and restart the machine.
Taping Defects Remedy
Indented Cut: Clean the blade using heavy rag & WD-40
or replace it if damaged. **BE VERY
CAREFUL, BLADE IS SHARP!!!**
Tape folding: Check that all rollers turn freely. Tape may
also be too thin or elastic and causing the
rear tape leg to “snap back” to box surface
before the rear roller wipes it down.