HL 721A/B 1351B Plotting Cutter User Manual
Page 6/27
5.4. Blade
Adjustment and Installation
5.4.1. Adjust the protruding length of the knife top as required for specific cutting media
。
Correct
Too long protruding
Too short protruding
length of knife point
length of knife point
5.4.2. Undo the screw of carriage holder. 5.4.3 Redo the screw of carriage holder.
When the tool is in appropriate position screw it and fix the screw.
With B model, the front holder is for ball pen, rear holder is for blade.
*
Make sure there is 1 ~ 2 mm gap between knife or pen tip and paper when the carriage lifts up.
5.5. Paper/Film
Setup
(
The LCD panel layout of B model is different than A model, but the key operations
are same
)
This machine is suitable for both single-sheet and roll paper (film).
Lift all feeding press wheels.
Line up paper at proper position (level and even) and lower the feeding wheels with avoiding any press wheel seats at the right joint of
two rolling shafts.
1. Turn on the power of machine (a red light of
Reset
button on LCD panel will be light on).
2. Press the
Offline/Pause
button on the LCD panel (a yellow light will be light on).
3. Press two arrow buttons (
↑
and
↓
) to check whether the paper and carriage move nice smooth, square and even.
Adjust the level spring to get a correct wheel pressure.
Knife adjusting screw
Knife handle
Knife
Knife sheath
Superficial
materials
Base paper
HL
HL
Offline
/Pause
Reset
Setup
Test Origin
Paper adjustment button operation
2
1
3
HIGHLIGHT
ELECTRONICS
