HL 721A/B 1351B Plotting Cutter User Manual
Page 17/27
After reset up USB 001, turn both machines off, and on again after a while, check the port settings again to confirm.
* Reboot PC every time after modification.
IF the blue progressing bar appears once click on
the “START” button BUT the cutting plotter does
not response, it normally indicates the installation
and configuration of Artcut is OK, please check:
1. USB cable (Music sound while plug/unplug)
2. The machine is under online mode and 9600
baud rate
3. Data settings port (9600 baud rate, 8 Dat bits, 1
Stop Bits, Even Check, Xon/Xoff Sequential
Control)
4. Printer of GOLDCUT JK Series as a default
printer & use USB 001 port as well
After check all of them, reboot both machines
USB001
HL-721(HPGL)
HL-721(HPGL)
HIGHLIGHT
Parameter
USB001
HL 721 (HPGL)
USB001
Even
Alternative Manufacturers: Jinka
JK721(HPGL) or JK1351(HPGL)
HIGHLIGHT
ELECTRONICS