Highlight 200201, Руководство пользователя

Страница: 16 / 32

15
Ordercode: 200201
TF-300 Fresnel CW
Control Panel
A)
B)
C)
D)
E)
F) LC-display
Home button
Return button
Enter button
Up button
Down button
Fig. 07
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it,
the controller will display the saved DMX address the next time.)
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the Fresnel will respond to the controller.
Please note when you use the controller, the unit has 5 channels.
When using multiple Fresnels, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Fresnel should be 1(005); the DMX address of the second Fresnel
should be 1+5=6 (006); the DMX address of the third Fresnel should be 6+5=11 (011), etc.
Please, be sure that you do not have any overlapping channels in order to control each Fresnel correctly.
If two or more Fresnels are addressed similarly, they will work similarly.
Controlling:
After having addressed all Fresnel fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the Fresnel will automatically detect whether DMX 512 data is received or not. If
not the problem may be:
●
The XLR cable from the controller is not connected with the input of the Fresnel.
● The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.