HIGHLEAD GC20688-BDC, Инструкция по эксплуатации

Страница: 21 / 61

(1) Set free blocked hook.
til the pin can be stuck in the drill-holes of both clutch parts.
k is freely movable again.
k and turn the pulley until safety clutch 2 engages.
ould adjust the torque transmittable from safety clutch .
lly, the
necess
, clockwise rotation , the
Sewing machines with this device make possible the cutting of the material during the sewing sequence.
The vertical cutter does not function during each pneumatic lift of the dewing feet. During operation of the
knee lever this is only the case after 2/3 lift. To start the vertical cutter after the operating lever down.
Caution Risk of Injury!
Turn the main switch off. Set the vertical cutter only with the sewing machine turned off.
(2) Stick a pin in drill-hole 1 of the outer clutch disc.
(3) Turn the pulley un
(4) Turn the pulley forwards and backwards until the hoo
(5) Pull out pin.
(6) Hold down hoo
Adjust transmittable torque
Standard checking
The supplier by means of a torque spanner sh
(1) Loosen counter-nuts 3.
(2) Adjust torque
(3) Tighten counter-nuts 3 again.
34) Regulate the atmospheric pressure
When the air cylinder works norma
ary atmospheric pressure is 5.5~6.5bar. Can
find out through the dial plate of the filtering .
—
18
—
(1) Lifting knob 1
pressure increases.
(2)Lifting knob 1, anticlockwise rotation, the
pressure is reduced
5. HOW TO USE THE VERTICAL CUTTER