F
CAUTION: HIGH
g
VOLTAGE
!
RISK OF ELECTRIC SHOCK
!! WARNING !!
SET AC VOLTAGE SELECTION INSIDE BEFORE USE
HEALTH AND SAFETY
-
Always read these complete instructions before operating the equipment.
-
Always use a properly grounded IEC cable with this equipment and never defeat the
grounding pin as this provides not only a safety ground but is required for low noise
operation.
-
Avoid using this equipment around stray magnetic fields. The enclosure is designed to
shield the circuits from magnetic fields and radio interference and so during racking of
the equipment it’s important to ensure typical grounding procedures are followed.
-
Avoid the use of the equipment in high temperature environments as this can degrade
the performance and reduce the lifetime of the internal components.
-
There are some internally accessible adjustments in this equipment. If there is a
requirement to perform internal adjustments, please ensure one is comfortable with
opening the equipment and performing said adjustments. Please seek qualified
assistance if unsure.
-
If adjustments are to be made to this equipment, please disconnect the equipment from
mains power prior to opening the equipment and performing the adjustment. While we
understand that some adjustments are to be made with the equipment live, any damage
to the equipment as a result of dropped metal objects or liquid damage will not be covered
by the warranty.
HIGH VOLTAGE AUDIO reserves the right to change the specifications or modify the designs of
its equipment. Company contact information is on the last page of this manual.
VOLTAGE SELECTION AND FUSE
This equipment is capable of operating over a range of mains voltages to cater for various
regions. Please ensure the correct mains voltage setting and correct fuse are used prior to
connecting the equipment to mains. To avoid the risk of fire, replace the mains fuse only with
the correct value.
For mains voltages from 100-120 VAC, use a T200mAL (M205 SLO-BLO only) and configure the
internal mains voltage selector to display 115V. For mains voltages from 200-240 VAC, use a
T100mAL (M205 SLO-BLO only) and configure the internal mains voltage selector to display
230V.
