Page 34/34
the airtube
directly
between air tank and retract valve (do not install the collar on the side
of the air retract or between air tank and filler valve). The retract speed can now be
adjusted by tightening the wheel collar screw. Take care not to puncture the airtube.
It is recommended to program your radio so that the steering servo is disabled in the
“retract up” position.
Step 15: The first flight
If you do not have retracts installed use a bungee to launch the plane (use a few clicks of
up trim for the first launch). Retract equipped models, should do a few taxi runs so that
you get a feeling for the plane. It will also allow you to do the last adjustments to the nose
gear steering to allow the plane to run straight.
After take-off, do not attempt to turn the plane immediately. Instead climb and trim the
model. Once you have sufficient height and airspeed turn and finalize the trimming.
We wish you many successful flights with your model. Happy Flying !!!
WARNING!
Although the Sniper 90 is a stable airplane it might cause serious personal injury
and property damage if out of control. We strongly urge you to seek the help of
an (AMA) approved instructor if this is your first aircraft. Only fly this model at
dedicated flying fields with sufficient safety measures in place.
High-end Technology Holland, distributors and re-sellers assume no liability for the operation or
performance of this product. It is the responsibility of the operator to use this product in a safe
and responsible manner
Manual Design by RC
-
WaRbiRDs
WWW.RC
-
WaRbiRDs.CoM