Hifonics ZEUS ZXi 1500, Руководство пользователя

Страница: 11 / 20

Fuse
Installation Notes
A car audio amplifier is generally mounted in the rear trunk area but can be mounted in any convenient area such as beneath a seat.
Please be sure to locate this unit where you have reasonable air circulation and protection from moisture. When considering the
mounting location you should minimize the length of the power and speaker leads. Minimizing both leads will yield a more reliable
installation. It is also important to ensure that the heat sink fins are not against a panel or a surface, preventing air circulation. Do not
install the amplifier on a subwoofer box or on vibrating parts of the vehicle, vibrations can cause damage to the amplifier.
Installation of the amplifier
Before starting with the installlation, mount the provided mounting brackets on the
amplifier. Mark the location for the mounting screw holes by using the amplifier
as a template. Drill holes at the marked locations and firmly fasten the amplifier
in place with the mounting screws supplied in the accessory kit. Before drilling
or cutting any holes, investigate the layout of your automobile thoroughly:
Take care when working near the gas lines or hydraulic lines and electrical wiring.
Electrical Connection
Ground (GND)
This wire is the electrical ground and must be fastened securely to the vehicle`s chassis. The best method is to use a threading sheet
metal screw since the threads cut into bare metal. Ensure that all paint or other insulation is removed from around the hole area, and
using self tapping screw, securely affix the bare wire ends to the vehicle´s chassis. Use as short a piece of cable as possible - use the
same gauge as was used for the +12V cable. Make sure that the connection is safe and stable.
Battery Connection (+12V Power)
Connect this wire to the positive battery terminal. Please use a sufficient gauge (min 16 mm) with spade lug with insulating sleeve.
WARNING: The amplifier is not equipped with an internal fuse. Please install by any means a sufficient Fuse between the
Battery and the power 12V terminal of the amplifier. Ensure that the Fuse is located very close to the Battery.
Please use the following Fuse Ratings:
ZXi1500 = 100A (4/2 Ohm Operation) or 120 A (1 Ohm Operation)
ZXi2200 = 140 A (4/2 Ohm Operation) or 160 A (1 Ohm Operation)
Remote (REM)
Connect the remote wire of your head-unit with the remote turn-on (REM) of the amplifier.
11
Installation
Battery
12 V
Ground-Connection
to vehicle's chassis
Ground-
Connection
Remote Wire (REM)