Hifonics Vulcan VXi1201, Руководство пользователя

Страница: 17 / 28

17
ELECTRICAL INTERCONNECTION
INSTALLATION INSTRUCTIONS
ELECTRICAL INTERCONNECTION
4
FUSE
The inserted fuses protect the amplifier from shorts and capacity overload.
1
2
3
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wire kits. Ensure a sufficient profile section
(at least 25 mm
2
), the suitable fuse rating and the conductivity of the cables when you purchase your wiring kit. Clean and remove rust-
streaked and oxidized areas on the contact points of the battery and the ground connection. Make sure that all screws are fixed tight after
the installation, because loose connections cause malfunctions, insufficient power supply or interferences.
GND
Connect the GROUND terminal with a suitable contact ground point on the vehicle’s chassis. The ground wire must be as short
as possible and must be connected to a blank metallic point at the vehicle’s chassis. Ensure that this ground point has a stable
and safe electric connection to the negative “–”pole of the battery. Check this ground wire from the battery to the ground point if
possible and enforce it if required. Use a ground wire with a sufficient cross section (at least 25 mm
2
) and the same size like the
plus (+12V) power supply wire.
REM
Connect the turn-on signal (e.g. automatic antenna) or the turn-on remote signal of your head unit with the REM-terminal of the
amplifier. Use therefor a suitable cable with a sufficient cross section (0,5 mm
2
). Hereby the amplifier turns on or off with your
headunit.
BATT+12V
Connect the BATT+12V-terminal with the +12V pole of the vehicle’s battery. Use a suitable cable with a sufficient cross section
(at least 25 mm
2
) and install an additional in-line fuse. For safety reasons the distance between the fuseblock and the battery
should be shorter than 30 cm. Do not set in the fuse into the fuseblock until the installation is accomplished.
1 3 2 4
PHASE
POWER INPUT
SPEAKER OUTPUT
PROTECT
POWER
LP
SUB
SONIC
BP
LEVEL
0dB 12dB
LINE OUT
15Hz 55kHz 35Hz 250Hz MIN MAX
GND +12V REM
BASS
BOOST
LINE IN
L L
R
VXi 1201
FUSE
BASS LEVEL
CONTROLLER
O ° 180 °
R
FULL HP LP/BP
X-OVER MODE