Hifonics Brutus BRZ 1200.1D, Руководство пользователя

Страница: 5 / 14

INPUT OUTPUT INPUT LEVEL
PHASE REMOTE BASS EQ SONIC LOW P
ASS
L
L
R
R
SUB
POWER PROTECT
BALANCED
9V 0.2V 0 180 0dB 10dB 15Hz 35Hz 35Hz 250Hz
SPEAKER OUTPUT
- - + +
GND REM BA
TT+12V
POWER INPUT
FUSE
INPUT OUTPUT INPUT LEVEL
PHASE REMOTE BASS EQ SONIC LOW P
ASS
L
L
R
R
SUB
POWER PROTECT
BALANCED
9V 0.2V 0 180 0dB 10dB 15Hz 35Hz 35Hz 250Hz
SPEAKER OUTPUT
- - + +
GND REM BA
TT+12V
POWER INPUT
FUSE
HFR - 3
MI N MAXX
BOOST
3
BRZ1200.1D MONO AMPLIFIER APPLICATIONS
Basic application
Interconnect cable checklist:
- Connect the line inputs to a Radio/CD RCA outputs or line output of the
Minimum final loudspeaker impedance:
full range primary amplifier with good quality RCA cables. A “Y” adapter - 1 ohm.
may be needed as shown in the diagram.
- Use at least 16 gauge speaker wiring. These amplifiers have dual
speaker terminals, simplifying the hookup of multiple speakers. The 2
positives are the same and the 2 negatives are the same.
Crossover frequency control checklist:
- LOW PASS: 35Hz to 250Hz
- SUBSONIC:15 Hz to 35 Hz
- BASS EQ: 0 to 10dB
- PHASE: 0 to 180 degrees
Level control checklist:
- Refer to the section
“Setting up systems after installation for best
performance”
FULL RANGE
STEREO LINE INPUT
NOT USED
Y-ADAPTOR
Note: You can use the Radio/CD designated mono line output
or a full range stereo line output. For full range stereo line output,
you will need an optional “Y-Adaptor” as shown
*
HFR - 3
MI N MAXX
BOOST
REMOTE TURN-ON
CHASSIS GROUND
TO B12v
VIA FUSE
PARALLEL MONO
SUBWOOFERS
2- OHMS SVC EACH MINIMUM,
or 4-OHMS DVC EACH MINIMUM
MONO
SUBWOOFERS
Dual Subwoofer Application
REMOTE TURN-ON
CHASSIS GROUND
TO B12v
VIA FUSE
MONO
SUBWOOFER
1-OHM MINIMUM
DESIGNATED
MONO LINE INPUT
*
DESIGNATED
MONO LINE INPUT
*