If not, turn power off, swap the wires on U and V, turn power on and check again.
Do not allow the pump to rotate anticlockwise or the pump and/or motor will be
damaged and warranty will be void. If the motor continues spin backwards, turn
everything off and call for service advice.
NOTE: Once installation is complete the internal ON/OFF switch will remain ON
and the isolator will be uesd as the main ON/OFF switch.
Do's and don'ts
Do
be careful with wiring.
Do
put your solar PV panels in a sunny position facing true north (southern
hemisphere) or true south (northern hemisphere). For best results tilt the panels at
an angle equal to your latitude.
Don't
run the pump dry, even momentarily, as warranty will be void.
Don't
use the pump in dirty and or contaminated water, Premature wear will not be
covered by warranty.
Don't
disassemble the controller. There are no user parts inside.
Do's
Strainer basket to be cleaned to prevent the pump from water starvation.
Do;s
Install spark arrestor for high voltage spoke.
Do's
Install appropriate AC breakers for panels &battery bank.
Hidro-SP 200W Exploded View
CHART
No.
ITEM
No.
ITEM
No.
ITEM
1
Inlet nut
10
Pump body screw
19
Guide plate
2
Connection O ring
11
Pump body gasket
20
Impeller
3
Inlet pipe
12
Deflate nail
21
Pump body seal ring
4
Filter O ring
13
Deflate nail O ring
22
Mechanical seal
5
Filter O ring
14
Screw
23
Pump cover
6
Pump body
15
Baseboard
24
Screw
7
Filter cover
16
Motor black
25
Water fender
8
Outlet pipe
17
Baffle
26
Screw
9
Connection O ring
18
Guide plate seal ring
27
Motor
7
