- Move
to
, press
to start thermostatic heating function
，
on LCD blinks
。
2 seconds later, thermostatic heating function starts or stops according to the temperature
（
the
temperature that the system defaults is 40
o
C
）
：
Controlling rule is as follows:
If the temperature
≥
setting temp1
℃，
stop heating;
If the temperature
≤
setting temperature -1
℃，
start heating.
- Press
again to stop the function.
- Temperature adjustment
- When the thermostatic heating function is on, press
till LCD shows
and
or
, then press
or
once; and the temperature shall be increased or decreased 1
℃
.
- Temperature setting range
：
30
℃
--45
℃
4. Cleaning & Maintaining
1. Cleaning with liquid scour and soft cloth caution: acetone, ammonia, carbinol, formyl, formaldehyde etc are
forbidden.
2. If there are some scratches on the surface, polishing them with 2000#sandpaper, then plaster some toothpaste
and use soft cloth to keep the whirlpool shining.
3. Exterior furring can be removed by acid scour and soft cloth, you’d better use hot citric acid, vinegar for clean.
4. If you find the overflow and drain are blocked by dirties, screw it off and clean.
5. Gold and chrome finished accessories don’t need much wiping.
6. Don’t clean the bathtub with rough tools or detergent with chemicals solvents.
7. When you finish using the bathtub, drain and power off.
8. Don’t hammer and carve the shower room with blunt object or some thing very sharp.
9.Filling the whirlpool fully with 40
warm water for whole whirlpool clean, mixed with 2g scour and start the
℃
massage power for about 5 minutes, switch and drain, then filling cold water fully and start the massage power for
about 3 minutes, drain and whirlpool clean finished.
5. Safety Guide
1. Whirlpool should be installed by professional worker, or we will not responsible for it
2. Electrical source parameter should according to national standard, such as including creepage protecting switch.
Pay attention to the switch, the electric outlet and the Electric wire are all waterproof.
3. Don’t use over hotted water, and obey the rules: cold water first, hot water next. Do not power on unless the
water covers the jets.
4. We allowed 220V standard for the bathtub. Do not power on, if the voltage=235V or =190V.
5. Make sure you power off after using the bathtub.
