OPERATION
The spa will automatically begin to operate when electrical power is applied. There is no ON/OFF switch for the
spa system; do NOT apply power without first filling the spa with water.
The control system has been designed so that by connecting the spa to its properly grounded power source, it will
begin to operate. The Status/Heat LED will light briefly. The pump will activate if the temperature of the water is less
than 65
°
F.
Control Panel
The Control Panel is easy to use with fingertip control of all the spa functions.
Temperature Control
To increase the temperature, turn the Temperature
Control Knob clockwise to the desired setting. To
reduce the temperature, turn the knob counter clock-
wise.
Function Control Button
Press the Function Control Button once and the low
speed pump will operate. Press the button again and
both the low speed pump and spa light will operate.
Press the button a third time and the high speed pump
and spa light will operate. Press the button a fourth time
and the high speed pump will operate without the light.
Push the button again and the system will turn off.
Note: The Defino is not factory equipped with a lamp
package.
Filter Cycles
Your spa will automatically filter itself twice a day.
During filtration, the low speed pump will activate. The
first filter cycle will begin one hour after the spa has been
STATUS/
HEAT
WARM
STATUS/HEAT
INDICATOR
COOL
FUNCTION
CONTROL
BUTTON
OFF
LOW
LOW / LT
HIGH
•••
••••
•••••
•
••
HIGH / LT
TEMPERATURE
CONTROL
KNOB
energized. The second cycle will begin twelve hours
after the start of the first cycle.
Over Heat Protection
In the event the spa should overheat, the Status/
Heat LED will flash and the spa will shut down. If this
situation occurs, turn off all power to the spa and contact
your dealer or service organization. To reset the spa,
press the Function Control Button.
Flow Switch Detection
If the pressure switch malfunctions, the Status/Heat
LED will flash. If this situation occurs, turn off all power
to the spa and contact your dealer or service organiza-
tion.
Open Sensor
If either the high limit or water temperature sensors
malfunction, the Status/Heat LED will flash. If this
situation occurs, turn off all power to the spa and contact
your dealer or service organization.
ADDENDUM
DELFINO OPERATION AND MAINTENANCE
(OVER)
