Hidromasajes Estilo GT-0532, Руководство по установке

Страница: 20 / 24

20
Silicone Seal where shown in red on the inside of the shower
TESTING FOR WATER LEAKS
LEAVING SHOWER 24 HOURS AFTER BUILD ALLOWING SEALENT TO CURE
With all connections tight, the waste and hoses checked, jets fully sealed, your shower still around 18 inches
from its designated final resting point and the silicone fully cured (hence leaving for 24 hours minimum)
Switch on the overhead shower NOT the massage jets, remember these will fire water out at you and are
not suitable for checking leaks as they would normally only operate when a person is in front of them. Just
use COLD water setting as hot will make cabin misty and condensate thus the inspection becomes very
difficult. Now on the OUTSIDE of the shower inspect each joint, factory seal, hose, clip and jet by walking
from one side and going around to the back and then to the other side finishing at the front. If you have a
small leak (normally caused through insufficient sealer or air bubble on assembly, dry the area thoroughly
and reseal on the OUTSIDE. Please remember where you see the water this may not be exactly where the
leak is as it could have run around to a low point. Never seal your inner fittings (accessories) inside unless
you feel it necessary and make sure it is thin and neat, remember you will see this for the life of the shower!
Again leave to cure and check. If all good now check shower functions i.e. jets for back massage,
foot massage, (if you have one) and finally hand shower, check your joints to these functions at the rear
again. Never use the shower until all checks have been made and the installer is 100% happy in the
knowledge no leaks are present.
All good?
Now push your shower FROM THE BASE NEVER GLASS OR FRAME into its final resting position.
Now you can shower in the knowledge that you have no leaks a job done well and long product life.
Happy showering!
Silicone the area highlighted in red
where the glass panel frame meets at
the bottom (next to the column)
Silicone fill the area highlighted in red at
the end of the bottom runner as
indicated in the image on the left.