VertX V1000 (CS) Quick Installation Guide
Syst e m Tim e
System Time provides the ability to view and set the date, time, and time zone values on the controller.
Upon initialization, Date, Time, Time Zone and TZ fields will be populated with the current system settings. The
date displayed (non-text box) will be updated approximately every 30 seconds.
date displayed (non-text box) will be updated approximately every 30 seconds.
The
Time Zone
Time Zone
field provides a drop-down menu. One of the options in the
drop-down menu is
Custom Time Zone
. If
Custom Time Zone
TZ
is selected, the
text box will be enabled. Otherwise, the TZ is
associated with the
Time Zone
field.
Upda t e Syst e m
Update System allows the user to update the firmware on the interface board. During a download the interface
board image flashes between grey and yellow. When a download completes the image color changes to green
for successful or red for failure. If the download fails, a tool tip with the error status code may be viewed by
hovering the mouse over the image in question.
Initially, all of the interface boards will be selected for a download to commence.
Note
: Depending on the VertX controller and system, it may take several minutes to completely download.
N e t w or k D e fa u lt s Ju m pe r
The
Network Defaults Jumper
requires that someone with physical access to the V1000, place a jumper over
the debug port prior to the controller rebooting. The controller reconfigures its network settings to the factory
defaults when the jumper is on the debug port during a reboot. From this point, configuration (or re-
configuration) will proceed normally.
Use the Network Defaults Jumper to correct potential errors in a VertX controllers network configuration.
1. Place a jumper over the right two pins of the P9 debug port.
2. Reboot the controller to change
all
of the network configuration settings back to the factory defaults.
3. After the LED turns amber, remove the jumper from the P9 debug port. Upon removing the jumper it
takes approximately 60 seconds for the controller to reset. Once the reset is complete, the LED will
return to green.
October 2006
Page 15 of 20
© 2006 HID Global Corporation. All rights reserved.
