HHP IMAGETEAM 4600, Руководство пользователя

Страница: 55 / 234

IMAGETEAM™ 4600/4800 User’s Guide 3 - 9
LED Power Level
This selection allows you to adjust LED and aimer brightness. Off is used when
no illumination is needed.
Low is used if low illumination is sufficient. High (the
default) is the brightest setting.
If you have an aimer delay programmed (see Aimer Delay on page 3-10), the
aimer will be at 100% power during the delay, regardless of the LED Power
Level.
Note: If you scan the Off bar code, both the aimer and illumination lights turn off,
making it impossible to scan bar codes in low light. To turn the LED
Power Level back on, move to a brightly lit area and scan either the Low
or the High bar code below.
Illumination Lights
If you want the illumination lights on while reading a bar code, scan the Lights
On bar code, below. However, if you want to turn just the lights off, scan the
Lights Off bar code.
Note: This setting does not affect the aimer light. The aiming light can be set
using Aimer Mode (page 3-11).
Off
Low (50%)
* High (100%)
Lights Off
* Lights On