HG soldatech EL120HG, Руководство пользователя, Страница: 26 / 39

ENG
26
POWER INDICATOR
When the machine is turned on, the power indicator will be on.
ALARM INDICATOR
When the thermal indictor is on, it shows the machine is overloaded and the
internal temperature is too high. Weld output will turn off automatically but
the fan will still be working. When the internal temperature is decreased, the
overload light will turn off and the machine will be ready to weld.
WELDING CURRENT
Welding Current is on the front panel of machine. It is an infinite current out-
put adjustment.
WELDING CABLE
The welding cable are attached to electrode to complete the circuit, allowing
the flow of current needed to weld.
GROUNDING CABLE
The ground cable/clamp are attached to the work piece to complete the cir-
cuit, allowing the flow of current needed to weld.
POWER SWITCH
In the “oFF” position no power is being supplied.
In the “ON” position power is supplied to the main transformer and control
circuit.
POWER CORD
The power cord connects the welder to the 230 volt power supply. 16 amp
receptacle to supply power to the welder.
Installtion
Power requirement
AC single phase 230V, 50/60HZ fused with a 30amp time delayed fuse or cir-
cuit breaker is required.
• High voltage danger from power source! Consult a qualified electrician
for proper installation of receptacle. This welder must be grounded while
in use to protect the operator from electrical shock.
• Do not remove grounding prong or alter the plug in any way. Do not use
any adapters between the welder’s power cord and the power source
receptacle. Make sure the POWER switch is OFF when connecting your
welder’s power cord to a properly grounded 230Vac, 50Hz, single phase,
30 amp power source.