Dehumidifier BT 60
EN
33 / 42
The operating status is shown at the display.
The device runs in continuous mode.
The device is switched on.
Switching device off
a) Press the ON/OFF button at the control panel.
The display is switched off.
b) If necessary, read the operating hours and kWh
counters and document the values.
The device is switched off.
Operation of integrated hygrostat
The hygrostat functions and display texts are shown
in the table below.
Step
Button Description
Switching hygrostat on and adjusting settings
Press
and hold
HYG SET RHxxx%
– flashes for
5 seconds. The device changes to
hygrostat mode with setpoint
(when the setpoint is reached,
INT
HYG STOP
is shown on the dis-
play.
Press
When
HYG SET RHxxx%
flashes,
briefly press +/- buttons to set the
RH% value. The value is saved 5
seconds after the respective but-
ton is released.
Switching hygrostat off (HYG OFF).
Press
and hold
until
button
flashes
HYG SET RHxxx%
– flashes for
5 seconds.
Press 1x
(while
display
flashes)
HYG OFF
flashes. The settings
are saved 5 seconds after the
button is released. The device
switches to continuous mode.
Operation of external hygrostat
If an external hygrostat is connected, the device
automatically switches automatically to operation
with external hygrostat.
The setpoint set at the external hygrostat now ap-
plies. When this setpoint is reached,
EXT HYG
STOP
is shown on the display.
Operating hours counter
The operating hours counter shows the total operat-
ing hours (not resettable) as well as the hours until
the next service (service hours counter). The service
hours counter can be reset. It is switched off when
the device is delivered.
Step
Button Description
Setting service hours counter
Press and
hold
SERVICE xxxxh
– indicates the
hours until the next authorised
service is due. The displayed
value flashes for 5 seconds, and
is then stored to activate the
function (unless it is already
active). When the set service
interval has elapsed, message
"SERVICE" is displayed.
To enter the new service inter-
val, briefly press +/- buttons. The
value is saved 5 seconds after
the respective button is re-
leased.
Switching service hours counter off (SERVICE
OFF).
Press and
hold until
button
flashes
SERVICE xxxxh
– indicates the
hours until the next authorised
service is due.
Press 1x
(while
display
flashes)
SET SERVICE OFF
– switches
service hours counter off
The value is saved 5 seconds
after the respective button is
released
Emptying water tank
When the "FULL" indicator is lit, empty the water
tank. Also empty the tank when the device is to be
transported or put into storage.
To empty the water tank, it is not necessary to shut
down the device. It is automatically switched off
when the water tank is removed.
Fig. 36:
Emptying water tank
1 Recesses
2 Handle
a) Hold the water tank by the handle and pull it
halfway from the device.
b) Hold the water tank by the recesses to the side
and lift it from the device.
c) Drain off the water through the lateral spout.
1
1
2
