Dehumidifier BT 60
EN
31 / 42
Fig. 30:
Mounting handle
e) Remove the protective foil from the control pan-
el.
f) Check the delivery for completeness.
Report any transport damage or incomplete de-
livery to your dealer.
g) Dispose of the packaging in accordance with
the applicable statutory regulations.
h) Make sure that a clean and intact filter is fitted in
the air inlet grille.
i) Make sure the power cord is not damaged.
j) Make sure that the water tank is correctly in-
stalled.
Transporting the device on site
The device can be transported by two persons work-
ing together or by crane. Proceed as follows:
Observe the relevant occupational health and safety
rules for the lifting of heavy loads!
Fig. 31:
Transport by two persons or by crane
– One person must hold the device by the handle;
the other person must hold the device by the
housing (see arrows):
– Place a hoisting sling around the housing.
NOTICE! Observe the centre of gravity of the
device to ensure that it cannot slip from the
sling.
– The wheels are attached so that the device can
be pulled up steps and stairs without damaging
the housing or the stairwell.
Positioning device
The device contains flammable refrigerant. There-
fore, its location of installation must meet the follow-
ing requirements:
– For best performance, the device should be op-
erated in closed rooms.
For operation and storage, the room must
measure minimum 4 m
2
.
– Close all windows, doors and opening to other
rooms to prevent that the dried and the humid air
mix.
Open doors only when absolutely necessary.
– Position the device so that the air flow through
the intake and outlet openings is not obstructed.
– Do not place the device near a heat source,
such as a radiator, etc.
– Keep the device away from loose objects, includ-
ing curtains, etc.
– Place the device in a position where air circula-
tion is unobstructed; maintain a minimum dis-
tance of 60 cm and 3 m to the nearest wall at the
air intake and air outlet side respectively.
Fig. 32:
Minimum distances and room size
– The room temperature must be within the per-
missible operating range of the device. Other-
wise, the device does not work (see also
Stacking devices for operation or storage
For operation or storage, it is permissible two com-
bine two devices in a stack.
a) Loosen the star grip screws of the device
placed at the bottom.
b) Push the handle to the bottom stop and tighten
the star grip screws.
300 cm
60 cm
Min. 4 m
2
