Installing the Media Module adapter
CAUTION:
The maximum inlet ambient temperature for most components installed in the system is
35°C (95°F). Some components, however, are subject to thermal limitations depending on the
chassis model and the fan configuration. There are some hardware configurations where it is
necessary to limit the number of drives installed in the chassis. For more information, see
.
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
2.
Disconnect all peripheral cables from the server.
3.
Remove the server from the chassis
on page 28.
4.
on page 30.
5.
Remove the secondary riser cage
on page 33.
6.
Do one of the following:
•
Remove the primary riser blank
on page 35
•
on page 36
7.
Remove the Media Module blank.
8.
Install the Media Module adapter. Make sure that the board is firmly seated in the slot.
100
Hardware options installation
