Hewlett Packard Enterprise HPE ProLiant XL230k Gen10, Руководство пользователя

Страница: 7 / 82

Item Description Status
1 Power on/Standby button and System
power LED
1
• Solid green = System on
• Flashing green (1 Hz/cycle per sec) = System
attempting to power on
• Solid amber = System in standby
• Off = No power present
2
2 Health LED • Solid green = Normal
• Flashing green (1 Hz/cycle per sec) = iLO is
rebooting.
• Flashing amber = System degraded
• Flashing red (1 Hz/cycle per sec) = System critical
3 NIC LED • Solid green = Link to network
• Flashing green (1 Hz/cycle per sec) = Network
active
• Off = No network activity
4 UID LED/button • Solid blue = Activated
• Flashing blue
◦ 1 Hz/cycle per sec = Remote management or
firmware upgrade in progress
◦ 4 Hz/cycle per sec = iLO manual soft reboot
sequence initiated
◦ 8 Hz/cycle per sec = iLO manual hard reboot
sequence in progress
• Off = Deactivated
1
When all four LEDs described in this table flash simultaneously, a power fault has occurred. For more information, see
"
Front panel LED power fault codes on page 7."
2
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has
occurred, or the power button cable is disconnected.
Front panel LED power fault codes
The following table provides a list of power fault codes, and the subsystems that are affected. Not all power
faults are used by all servers.
Subsystem LED behavior
System board 1 flash
Processor 2 flashes
Table Continued
Component identification 7