Use
no mvrp periodic-timer-enable
to disable the Periodic Timer on an interface.
MVRP registration modes
MVRP supports three registration modes:
• Normal
In this mode, a port can register and deregister dynamic VLANs. By default, the registrar mode is normal.
• Fixed
In this mode, a port cannot register or deregister dynamic VLANs. However, if a static VLAN exists in the
system, the port changes to registered state on receipt of join message.
• Forbidden
In this mode, a port does not register dynamic VLANs, ignores all MRP messages, and remains in MT state
(unregistered).
mvrp registration
Syntax
mvrp registration {normal |fixed}
Description
Configures the port response to MRP messages.
Parameters
normal
Port response is normal for the incoming MRP messages.
fixed
Ignores the MRP messages and remains registered.
Example output
switch# mvrp registration
fixed The port ignores all MRP messages and remains registered.
normal The port responds normally to incoming MRP messages.
switch(config)# interface A1 mvrp registration fixed
switch(config)# show mvrp config
Configuration and Status - MVRP
Global MVRP status : Enabled
Port Status Periodic Registration Join Leave LeaveAll Periodic
Timer Type Time Timer Timer Timer
------- -------- -------- ------------ ---- -------- -------- --------
A1 Enabled Enabled Fixed 20 300 1000 100
A2 Disabled Enabled Normal 20 300 1000 100
A3 Disabled Enabled Normal 20 300 1000 100
show tech mvrp
Syntax
show tech mvrp
84
Aruba 2530 Advanced Traffic Management Guide for
ArubaOS-Switch 16.09
