
The battery can be used for hundreds of times, when the life span reduced
obviously, change to a new battery please.
Please charging the battery in time to avoid it to be used up absolutely; otherwise it
will become useless forever, if the battery not be used for a long time, it will discharge
automatically. Make sure to charge it one time per/each quarter.
3. Usage of the tool
1) First you have to check the LED indicator is light or not. If the indicator is light on
for more than 5 seconds, it means no power of the battery and should change
the full powered battery to settle on the tool
2) Select the right dies for the Intended application.
Don’t operate the tool with our dies.
The crimping head has to be opened by pushing the latch, place two dies up
and down after activating the retaining clips. Then the connecting material shall
be positioned in the crimping head correctly in order to start the crimping
procedure.
3) A crimping process is initiated by switching the trigger. It is defined by the closing
motion of the dies. The connection material is positioned in the stationary half of
the crimping dies and the moving part is approaching the compression point.
4) A crimping cycle is terminated when the dies contracted each other and when
the maximum crimping force is reached. After the crimping cycles is completed
the piston retracts automatically. Afterwards a new crimping cycle can be
initiated or the crimping process can be terminated by opening the latch and
remove the connecting material out of the head.
3. Function description
1.
MCU - automatically detect the pressure during operation and
provide security protect, shut off the motor and reset automatically after
operation.
2.
Auto reset - release the pressure automatically, retract the piston to
the starting position when reached the max output.
3.
Manual reset - can retract the position to the starting positioning
in case of an incorrect crimp
4.
The unit is equipped with a double piston pump which is
characterized by a rapid approach of the dies forwards the connector and a
slow crimping motion.
5.
The crimping head can be smoothly turned by 360° around the
longitudinal axis in order to gain better access to tight corners and other
difficult working areas.
6.
One significant sound will be heard and a red display
flashes if any error occurs.
A white LED illuminates the working space after activating the trigger. It
automatically switches off 10 sec. after releasing the trigger.
7.
The whole tool is controlled by one trigger. This results in any easy
handing and a better grip compared to a two button operation.
8.
Li-ion batteries do neither have a memory effect nor self discharge.
Even after long periods of non operation, the tool is always ready to operate.