UNDERSTAND YOUR TOOL
HL-45B for cutting Cu/Al cable and armored cable. It carries more advantages of
high efficiency, easy operate, automatic retract, 360° rotary cutting head, ETC. It is
powered by Li-ion, actuated by motor and controlled by M C U. With a high pressure
hydraulic system, it is a perfect tool to be used in electrical construction site.
1. Specification
Max. cutting force:
60KN
Crimping range:
Φ
45mm (Cu/Al cable and armored cable)
Stroke:
50mm
Hydraulic oil:
Shell Tellus T15#
Ambient temperature:
-10 - 40
℃
Battery:
18v 3.0Ah Li-Ion
Cutting cycle:
5s-12s(depending on the connector size
）
Cutting/charger:
Approx. 130 times (Cu150 mm
2
)
Charging voltage:
AC 100V
〜
240V; 50
〜
60Hz
Charging time:
Approx. 2 hours
OLED display
：
display voltage, temperature, crimping times,
errors information
Accessories:
Blade:
1 pcs
Battery:
2 pcs
Charger:
1 pcs
Sealing ring of cylinder:
1 set
Sealing ring of safety valve:
1 set
SPECIFIC SAFETY RULES
1. Maintain labels and nameplates on the tool which carry important safety
information. If unreadable or missing, contact the agent to replace.
2. This product is not a toy, keep it out of reach of children.
3. Do not put your fingers into the head of the tool during operating. Your
fingers could be pinched very severely.
4. Make sure the head was locked firmly during operation.
5. Do not use the tool without dies.
6. Do not crimp on live cables or conductors.
7. Do not crimp copper or Al conducting material.
8. Do not knock parts of the tool, otherwise it will cause injury.
9. Do not operate at will, it will damage the MCU and electric system.
10. The design of the limit screw on the head is for preventing the head from
dropping or popping.
11. Make sure the head was locked firm during operation.
12. Do not use this tool for continuous use. After 30 to 40 cycles, allow the tool
to cool for 15 minutes.
13. Do not secure this tool in a vise. This tool is designed for hand-held
operation.
14. The built-in safety value goes through strict pressure test before marketing;
please do not adjust the pressure by unprofessional person. If the pressure
is not enough please return the tools back to the service center. The tool
only can be reused after checking and testing by trained person.
15. The warnings, precaution, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution are
factors which can not be built into this product, but must be supplied by the
operator.