HEWI
installation instruction
M1000_117_ES5400_EN_Vers-002.pdf
M1000.117
Page 5 of 7
HEWI P.O. Box 1260 D-34442 Bad Arolsen
After switching on the power-supply, a beep sounds. The red and green LED blink in change
every second. Simultaneously the relays are activated. This is because to ensure the door
opening with non-personalised wall-readers.
For further steps (esp. programming) see the manual of the HEWIKey 5 Administration
software.
Installation in metallic casings / surfaces:
The installation in metallic casings or surfaces is possible if:
•
Opening with a diameter of min. 70 mm
•
Installation of the wallreader with the installation-plate outside the metallic casing/surface.
•
Grounding of the metal-casing.
Description of known problems during installation including correctional
action
Connection cables are too thick and cannot be fitted into the connection-bar:
Please use luster terminals and a short linkup of the cable-type specified in the data-sheet
beyond.
Control of function
Please always check the complete function of the installation.
Maintenance
Basically the ES5400 doesn’t need maintenance. However, we recommend to check the
actuality of the internal time regularly. At least make the checks during the time switches
(summer- wintertime).
We further recommend a regulary check of the correct function of the wallreader, especially
in security-relevant areas. Security relevant can be every area, which will be affected by a
possible malfunction or wrong programming. This means especially alarm-systems, which
are operated by the wallreader or locks in escape- or outside-doors.
Please control the event-protocolls, which can be evaluated using the programming-device
and the HEWIKey Software. Coceivably you´ll find indications of a wrong-programming of the
locking system, which can be critical (e.g. an active toggle-function, which wasn’t planned or
an occured access from a person without access-rights to given time). In that case, please
check the correct programming of the wallreader first (especially time, holidays, special time
zones) and the ident-media (especially access-rights to given time, groups and validity). In
doubt, contact the HEWI Servicecenter locking systems, fon +49 5691 82 – 200.
Care
HEWI products are easy-care. Generally speaking, an occasional wipe with a damp cloth is
enough, however, you fell you have to use detergents, you should take note of the following
information: Only use detergents with ph-rating of between 6 and 8. Detergents containing
active substances such as phospates, soap and tensides may be used. Detergents
containing acids, alkalis, bleach or scouring agents may not be used. Nor should utensils
with a scouring effect such as brushes etc. be used. Usage of any detergent requires full
compliance with the manufacturer’s instructions (concentration, soaking time etc.).
If this is not done, the surface finishes of the HEWI products may suffer as a result and
sustain damage. HEWI accepts no liability whatsoever for damage occuring from incorrect
handling.
For further information please contact HEWI Servicecenter locking systems, fon +49 5691
82-200.