If alarms had been caused by both inputs, both messages 1 and 2 play. Message 3,
the common message, does not play. If the system is armed, message A also plays.
The messages repeat 3 times. The tones sound between messages: Two beeps for a
good battery; one for a low battery.
➥
NOTE:
If an alarm occurs during the interrogation mode, the system hangs up and
immediately starts the alarm calling sequence.
Remote activation of the programmable
outputs
Enter the user access code while the status messages are being played, or within the 20
sec pause after the messages have finished playing. If the first digit of the user code is
entered during the status message, the message stops indicating that the digit was
accepted. Enter the remaining digits then press
[
#
]
to confirm the entry.
Several quick beeps are heard to confirm that the correct code was entered. If an error is
made during entry, press [
✱
] then start over. Do not take too much time between entering
digits; it will hang up 20 seconds after the last button is pressed. To prevent an unauthorized
person from trying to break the code, and to prevent him from engaging the phone too
long, it will hang up after 1 minute of unsuccessful attempts.
After the quick beeps which confirm the correct code, tones are used to indicate the state
of the outputs:
– Neither output is active: Tone turns on and off slowly. 1 second on separated by 1
second off. It continues to repeat.
– Only output 1 is active: Short beep which repeats ever second.
– Only output 2 is active: 2 short beeps repeating every second.
– Both outputs are active: 1 short beep, a 1 second pause, then 2 short beeps, followed
by a 1 second pause. It continues to repeat.
To control an output
– Enter the number of the output: 1 or 2. If this is done during a status tone, it may not
be accepted. When a number is accepted, the status tones stop. If the status tones
continue, this indicates that the entry was not accepted; press the number again.
– Press
[
#
]
to confirm the entry. Or, press [
✱
] to cancel.
– The change in the status tones indicated the changed output states.
– When a momentary output is activated, the status tones sound for the 5 seconds it is
active.
Informa 300 Voice Message Communicator
21
