TW-800R-SLNX
11
6.Setting Method
6-1.Pairing (Registration)
The transmitter and the receiver need to be paired before use. By pairing the receiver and transmitter, they
recognize an identification signal from each other and communicate with each other.
The receiver can be paired with up to two transmitters.
6-1-1. Pairing procedure
①
While the power is on, press and hold the [Setting key] for 3 seconds or longer.
The Receiver (RX) LED blinks in green and the receiver enters the pairing mode for 10 seconds.
②
Long press the pairing switch of the transmitter for 3 seconds or more.
When Receiver (RX) LED turns from blinking (green) to OFF and then ID1 of the pairing ID indicator LEDs
lights up, the pairing is completed.
* If pairing is not performed during pairing mode, pairing mode will end.
When the receive (RX) indicator light is not blinking (green), it indicates that the pairing mode has ended.
To pair the receiver with the second transmitter, repeat
①
and
②
.
When Receiver (RX) LED turns from blinking (green) to OFF and then ID2 of the pairing ID indicator LEDs
lights up, the pairing is completed.
To pair the receiver with a different transmitter when ID1 and ID2 are already paired with transmitters, select
which you want to perform pairing to, ID1 or ID2.
After execution of
①
and
②
, Receiver (RX) LED turns from blinking (green) to OFF and ID1 blinks.
Press the [Setting(▲) key] in this state, and ID1 turns OFF and ID2 blinks. Press the [Setting(▼) key] while
ID2 is blinking, and ID2 turns OFF and ID1 blinks. Press the [Setting key] while the ID to be paired is
blinking, and the pairing is completed.
Setting key
Pairing switch (Test switch)
Power LED
Receiver (RX) LED
Pairing ID indicator LEDs (ID1/ID2)
Setting (▲/▼) keys
