11
Setting and Installation methods
This page and onward describe the setting for the communication (Communication channel
and Equipment No.).
If you use as a set combined with either of
“21D” Series Controller “21D-429C” or “21D-265C”,
setting has been completed before shipment. There is no need to make setting stated below.
Communication between Controller and Display is only available when the same
“Communication channel” and the same “Equipment No.” are set.
4-4. Setting the communication channel
The communication channel can be set by the rotary switch of wireless modem, that is,
either of
“TELEMATE III RB”
（
429 Communication type
）
or
“WCS-300R”
（
265 Communication type
）
built in the Display. Set the same channel as the one of equipment at Transmitter.
The wireless modem is at front of Display. Slide the acrylic plate at front to remove that
modem. Turn off the power source of Display before changing the communication channel.
※
Since the communication setting SW for TELEMATE III RB and WCS-300R is fixed before
shipment, do not change it. (ALLOFF)
※
For the 485 Communication type, TELEMATE III and WCS-300 are not built in.
TELEMATE III RB or WCS-300R (for setting communication channel) DIPSW
Rotary SW for communication channel
Front view
SW for setting communication
