ML Power 4
Advanced Web Manual
EN
9
9.
FRONT AND REAR PANELS
A PRE-IN:
Left and Right pre-amplified inputs to drive
A channels.
Connect to pre-amplified source output.
Signal can be 0.2 to 5V RMS.
PRE-OUT:
This jack provides A channel Left and Right
preamplified outputs to drive a separate amplifier
(typical with subwoofer). These signals are full range,
without crossover action.
B PRE-IN:
Left and Right pre-amplified inputs to drive
B channels.
Connect to preamplified source output.
Signal can be 0.2 to 5V RMS.
A HI - IN:
Hi-Level signals Left and Right inputs for A
channels.
If the head unit does not feature a pre-amplified
output, connect here its speaker wire to drive A Left and
Right channels. Signal can be 0.8V to 20 V RMS.
HI - IN AUTO TURN-ON (ON - OFF):
Select
ON
to turn on
the amplifier through the speaker power cable, if the
source does not feature a 12V DC REMOTE OUT. Select
OFF
if REMOTE OUT from the source is available.
B HI - IN:
Hi-Level signals Left and Right inputs for B
channels.
If the head unit does not feature a pre-amplified
output, connect here its speaker wire to drive B Left and
Right channels. Signal can be 0.8V to 20 V RMS.
B INPUT (A - B):
Select
A
to drive B channels with A input
signals. Whit this setup, do not connect B inputs. If the
source features a REAR output, select
B
and connect
its signals to B inputs (B PRE-IN or B HI-IN).
PROTECTION FUSE:
2 x 40A.
POWER (+ BATT):
Terminal block for the amplifier
11
÷
15V DC power supply positive pole connection.
Insert here the battery positive cable. The plug accepts
cables up to 2 A.W.G.
REMOTE IN:
REMOTE IN terminal for the remote cable
coming from the device which turns on the amplifier.
Voltage must be between 7 and 16V DC.
POWER (GND):
Terminal block for the amplifier power
supply negative pole connection
. Insert here the
battery negative cable or wire connected to the vehicle
chassis. The plug accepts cables up to 2 A.W.G.
BL Speaker OUT:
B channel Left s and - power
terminal.
For MONO (bridge) mode, connect the speaker
negative terminal to BL- terminal.
BR Speaker OUT
:
B channel Right s and -
power terminal.
For MONO (bridge) mode, connect the
speaker positive terminal to BR+ terminal.
AL Speaker OUT:
A channel Left s and - power
terminal.
For MONO (bridge) mode, connect the speaker
negative terminal to AL- terminal.
AR Speaker OUT:
A channel Right s and - power
terminal.
For MONO (bridge) mode, connect the speaker
positive terminal to AR+ terminal.
1
7
8
9
10
11
12
13
14
15
2
3
4
5
6
6
7
1
8
5
2
3
9
12
10
13
11
14 15
4
Содержание ML Power 1
Страница 22: ...All Specifications Subject to Change Without Notice ...
Страница 23: ......
Страница 24: ......
Страница 32: ......
