ENGLISH
Diagram 2 – Ceiling Mounted
The minimum installation height of the MANHATTAN above the
floor is 95” (2.4m) when ceiling mounted. Consideration should be
given to any temporary or occasional structures such as stages or
platforms and adjusted accordingly. Keep the cable and other
electrical connections outside the heater footprint.
For all installations, the MANHATTAN must be located in a position
to allow proper and efficient use but one that ensures hot parts are
not touched accidentally.
INSTALLATION:
Diagram 3: Bracket Assembly
Mounting Hardware Includes:
•
4 x bracket pieces - fit together
to form 2 brackets with a
central pivot. The protruding
blade on each bracket fits over
the circular end of the
opposing bracket to ensure
the correct pivot angle.
•
4 x M6x60 masonry expansion
bolts (for fitting brackets onto
wall).
•
2 x small bolts to fit brackets
onto the rear of the heater.
•
2 x small bolts and wing nuts
(to form the pivot on the
brackets).
Using the brackets as a template, mark and drill 4 x 8mm holes in the wall. Insert the plugs into the
wall and fit the brackets, washers, spring washers and nuts over the exposed threaded ends.
Tightening the nuts will force the plug end to expand in the wall and form a secure mounting for the
heater.
Fit the opposite bracket to the back of the heater before then inserting and tightening the bolt and
nut for each hinge.
HANDLING WHILE INSTALLING:
Take care while installing to avoid touching the grill on the front of the heater. Be sure to wipe away any
finger marks from the heater before the heater is first switched on, since the oils in fingerprints can burn
and cause rapid discolouration of certain parts.
